A tone control may be replaced with a StellartoneTonestyler. Please note that this company is no longer producing the ToneStyler. I still have a couple available for installation on JET Guitars.

Control Layout 1

Layout #1
Volume, Angled Megaswitch, and Tone. The switch, made in Germany by Schaller, gives standard Bridge or Neck pickup, plus single coil sounds. This layout requires a body thickness of 1.70" or more. This is the default layout for the Earlewood model.

Control Layout 2

Layout #2
Volume, Tone, and Megaswitch. This layout allows for a thinner body. Incidentally, the tone control is usually a master, but can be wired to exclude the neck or bridge pickup. Volume, Angled Megaswitch, and Tone. The switch, made in Germany by Schaller, gives standard Bridge or Neck pickup, plus single coil sounds. This layout requires a body thickness of 1.70" or more.

Control Layout 3

Layout #3
Angled Megaswitch, Volume, and Tone. Volume is normally the knob at the far end of the switch throw. A thinner body would accomodate this layout.

Control Layout 4

Layout #4
Volume, Straight Megaswitch, and Tone. This layout requires a body thickness of 1.70" or more.

Control Layout 5

Layout #5
Volume, Tone and Toggle Switch. A Push/Pull pot can be used to select single coil mode.

Control Layout 6

Layout #6
3 Knobs and Toggle Switch. Choose either 2 Volume / 1 Tone or 1 Volume / 2 Tone. You can have a thinner body with this layout, also. A special capacitor can be used for the bridge pickup tone control, to give it a more throaty midrange tone. This sounds great with overdrive!

Control Layout 7

Layout #7
This is the default layout for the Caldera model. Toggle Switch in Upper Bout, and 2 Volume / 2 Tone. The V/T for the bridge pickup is normally the row closest to the bridge. The upper Tone is a P/P pot to select single coil mode. A special capacitor is used for the bridge pickup tone control, giving it a throaty midrange tone like a wah pedal halfway down.

Control Layout 8

Layout #8 (PLUS System)
Toggle Switch in Upper Bout selects Piezo, Magnetics or both. Magnetic Volume / Tone, Volume for Piezo are placed near the bridge. The first knob is a P/P pot to select either of two pre-set tone curves for the Piezo.

Control Layout 9

Layout #9 (PLUS System)
Same as above layout, except Magnetic Volume / Tone, Volume for Piezo are placed further from the bridge.
For either PLUS layout, a miniswitch may be substituted for the P/P pot to select either of two pre-set tone curves for the Piezo.

Control Layout 10

Layout #10 (PLUS System)
Same as layout #8 except the pickup selector is a second toggle switch. The P/P pot can be used either to switch to single coil mode, or to select the piezo tone curves.

Control Layout 11

Layout #11 (PLUS System)
Toggle Switch in Upper Bout selects Piezo, Magnetics or both. Pickup selector is a second toggle switch placed next to the Magnetic Volume control. The back knobs are Tone (for mags) and Piezo Volume.

Control Layout 11

Layout #12 (Sustainer by Fernandes installed)
Volume, one or two (shown) Tone controls, 3-way Toggle. Two Miniswitches, with custom wood knobs, activate Sustainer and Harmonic modes.